Installing A2Z-Link

The unit connects to the control system via a network connection and all communications are done over IP. Power is applied via the included micro USB power adapter. The unit will boot up automatically when power is applied; there is no power switch.

1. Apply power and wait approximately 2 minutes. The LED on the unit will flash as the unit starts up.
2. The unit uses DHCP to obtain an IP address, to find the unit on the network, bring up a web browser on any computer that is connected to the same network. In the URL enter: http://find.homeseer.com
3. Click the Search button. The unit should then be listed; click on the link to connect to the unit.
4. Please refer to the Z-Wave section of this guide for information on managing Z-Wave devices.
5. For remote connections, myHomeSeer Remote can also be used. Create an account at http://myhs.homeseer.com. All you need is the license ID and password printed on the bottom of the unit. Once the account is created, you can log into the unit remotely at http://myhs.homeseer.com. If myHomSeer Remote is not to be used, it can be disabled from the Network tab in Setup.